KEITHLEY 705 scanner

$40.00

Out of stock

Category: Tag:

KEITHLEY 705 scanner

 

The Keithley 705 is a IEEE compatible scanner. The basic mainframe can accommodate two plug-in scanner cards. Each card can have different pole configurations. In the l-pole configuration the card has 20 channels, The 4-pole configuration allows 10 channels with two cards (for four-wire ohms).
 

Using the “daisy chain” method the Keithley 705, along with four additional Keithley 705’s, can provide up to 100 2-pole channels. The time and the date are kept internally with a battery backed up clock allowing time dependent procedures to be performed. The controls on the front panel allow opening a selected channel, closing the channel, scanning between a selectable first and last channel, selectable scan rate and mode. There are 13 internal programs that are accessible from the front panel. The programs can select primary address, dwell time, store a relay set up, recall the stored relay set up, control the digital l/O port, switch from International to American date format, control interval stop/start and select I-, 2- or 4 pole measurement modes.
 

The Keithley 705 Scanner adheres to standard IEEE-488 interface bus protocol. This enables the Keithley 705 to be incorporated into any measurement system that uses programmed control through the IEEE-488 bus.

 

  • Capacity: Two plug-in cards per mainframe
  • Expansion Capacity: Daisy chain allows up to 4 SLAVE units with 1 MASTER unit
  • Switching Rate: 100 channels/second (10ms), programmable to 1 channel/l6 minutes (999.999s)
  • Relay Drive: 350mA minimum
  • Internal Clock: Displays hours/minutes/seconds or date/month; less than 1 minute/month error (typical)
  • Battery Backup: Rechargeable 3.6V nickel-cadmium. 1 month retention of data (typical) with unit turned off.
GENERAL
  • Storage Environment: -25O to 65°C
  • Connectors: Four BNC; External Trigger, Alarm Out/Serial-In, Channel Ready, Serial Out (TTL compatible)
  • Power: 105-125V or 210-250V (internal switch selected), 50Hz to 400Hz. 25 V*A maximum. 90-IIOV and 180.220V version available
  • Dimensions, Weight: 127mm high x 216mm wide x 359mm deep (5″ x 8%” x 14%”). Net weight 3kg (6% lbs.)
  • Display: Six 0.5″ LED digits with decimal point, function and IEEE status annunciators
  • Operating Environment: 0° to 50°C, 0% to 80% relative humidity up to 35°C

 

Keithley 705 Scanner Mainframe 2 Switching Card Capacity. Power tested. No expansion cards or power cord included.

Weight 10 lbs
Dimensions 14 × 8 × 5 in

Reviews

There are no reviews yet.

Be the first to review “KEITHLEY 705 scanner”

Your email address will not be published. Required fields are marked *